1212
ENEN
ON timer and OFF timerON timer and OFF timer
Setting the ON TimerSetting the ON Timer
aa
ON buttonON button
Press Press the the ON ON button. button. Set Set the the timer timer to to the the desired desired time.time.
Each time the ON button is pressed, the time changes in Each time the ON button is pressed, the time changes in ten minute increments.ten minute increments.
Holding down the ON button changes the time in Holding down the ON button changes the time in one hour increments.one hour increments.
bb
SET buttonSET button
Press Press the the SET SET button button to to set set the the timer.timer.
The timer time is displayed, and the timer starts.The timer time is displayed, and the timer starts.
cc
CLR buttonCLR button
Press Press the the CLR CLR button button to to cancel cancel the the timer timer setting.setting.
Setting OFF TimerSetting OFF Timer
aa
OFF buttonOFF button
Press Press the the OFF OFF button.button.
Set the timer to the desired time.Set the timer to the desired time.
Each time the OFF button is pressed, the time changes Each time the OFF button is pressed, the time changes in ten minute increments.in ten minute increments.
Holding down the OFF button changes the time Holding down the OFF button changes the time in one hour increments.in one hour increments.
bb
SET buttonSET button
Press Press the the SET SET button button to to set set the the timer.timer.
The timer time is displayed, and the timer starts.The timer time is displayed, and the timer starts.
cc
CLR buttonCLR button
Press Press the the CLR CLR button button to to cancel cancel the the timer timer setting.setting.
..
Once you select timer oOnce you select timer operation mode, the settings are peration mode, the settings are saved in the remote controller.saved in the remote controller.
Thereafter, Thereafter, the the air air conditioner conditioner will will start start operating operating under under the the same same conditions conditions as as you you pressed pressed the the or or button button on on the the remoteremote
controller.controller.
YYou cannot set the ou cannot set the timer when the timer when the clock display is flashing.clock display is flashing.
Follow the instructions in the section “SettFollow the instructions in the section “Setting the clock” on pageing the clock” on page 6 to set the clock, and then set the timer6 to set the clock, and then set the timer..
TIMER OPERATION
TIMER OPERATION
CAUTIONCAUTION
•• When you select timeWhen you select timer operation, the remote r operation, the remote controller automatically trcontroller automatically transmits the timer sansmits the timer signal to the indoor unit at tignal to the indoor unit at thehe
specified time. Therefore, keep the remote controller in a location where it can transmit the signal to specified time. Therefore, keep the remote controller in a location where it can transmit the signal to the indoor unitthe indoor unit
properly.properly.
•• If If you you do do not not press press the the SET SET button button within within 30 30 seconds seconds after after setting setting the the time, time, the the setting setting will will be be cancelled.cancelled.
b
b
cc
aa
ONON
ONON
SETSET
SETSET
CLR
CLR
CLRCLR
OFFOFF
OFFOFF
SETSET
SETSET
CLR
CLR
CLRCLR
SETSET
ONON
OFFOFF
To Next Page
Loading...
