– 101 –
No. RemarksProceduresPart name
• Attachment
With the leads pointing downward and the sensor
leads pointing in the direction shown in the figure,
install the sensor onto the straight pipe part of the
condenser output pipe.
TS sensor
(intake
temperature
sensor)
TE sensor
(outdoor heat
exchanging
temperature
sensor)
• Attachment
With its leads pointing
downward, point the
sensor in the direction
of the packed valve,
and install it onto the
straight pipe part of
the intake pipe.
11
12
13
Detail B
Detail A
Arrow D
Detail C
Detail B
TD sensor
(outlet
temperature
sensor)
• Attachment
With its leads pointed
downward, install the
sensor onto the
vertical straight pipe
part of the outlet pipe.
Detail A
14 TO sensor
(outside air
temperature
sensor)
• Attachment
Insert the outdoor air temperature sensor into the
holder, and install the holder onto the heat
exchanger.
• Shown in the above figure is
the model 13EAVP-E.
• The sensor mounting positions
in the model 10EAVP-E are all
the same with the sole excep-
tion of the TE sensor. Refer to
the figure shown on the left.
CAUTION
During the installation work
(and on its completion), take
care not to damage the
coverings of the sensor
leads on the edges of the
metal plates or other parts.
It is dangerous for these
coverings to be damaged
since damage may cause
electric shocks and/or a fire.
CAUTION
After replacing the parts,
check whether the positions
where the sensors were
installed are the proper
positions as instructed. The
product will not be controlled
properly and trouble will
result if the sensors have not
been installed in their proper
positions.
Detail C for 13, 16EAVP-E
Detail C for 10EAVP-E
Arrow D
To Next Page
Loading...
