Toshiba RAV-HM1101KRTP-E - Automatic operation (auto changeover); Timer operation

Ŷ
Automatic operation
(auto changeover)
This function is available only for use in
combination with a heat recovery model outdoor
unit. If this function is used with another model of
outdoor unit, “A” (Auto) appears on the remote
controller but the automatic operation is disabled.
6WDUW
6:,1* )$1
4
3
1
2

67$576723EXWWRQ 
3UHVVWKLVEXWWRQWRVWDUWWKHDLUFRQGLWLRQHU

0RGHVHOHFWEXWWRQ02'(
6HOHFW$

7HPSHUDWXUHEXWWRQ 
6HWWKHGHVLUHGWHPSHUDWXUH

)DQVSHHGEXWWRQ)$1
6HOHFWRQHRI /2: /2:

 
0('
0('

 +,*+ 
 The OPERATION lamp on the display panel
of the indoor unit lights.
The operating mode is selected in accordance
with the room temperature and operation starts
after approximately 3 minutes.
 If the “A” mode is uncomfortable, you can select
the desired conditions manually.
6WRS
67$576723EXWWRQ 
3UHVVWKLVEXWWRQDJDLQWRVWRSWKHDLUFRQGLWLRQHU
CAUTION
'LVDJUHHPHQWLQRSHUDWLRQPRGH
If you select AUTOMATIC OPERATION in a model
with no auto-changeover (cooling/heating) control
setting or if you select HEAT in a Cool Only model,
lamp lights up and
and lamps blink
alternately with an alarm sound (pi, pi) from the
air conditioner due to disagreement in operation
mode. Change the operation mode with the
Ŷ
Timer operation
Use the wired remote controller for timer setting if it
is also in use.
21WLPHUDQG2))WLPHU
6:,1* )$1
),;
48,(7
+L32:(5
&20)257
6/((3
2
1
3
6HWWLQJ7,0(5

212))7,0(5EXWWRQ RU 
3UHVVWKH21RU2))7,0(5EXWWRQVDVUHTXLUHG
 The previous timer setting is displayed and flashes
along with ON/OFF timer display.
Set the timer to the desired time.
Each press of the TIMER button changes the
time in ten minute steps.
Pressing the TIMER button continually changes
the time in one hour step.

6(7 EXWWRQ
3UHVVWKH6(7 EXWWRQWRVHWWKHWLPHU
7KHWLPHUWLPHLVLQGLFDWHGDQGWKHWLPHUVWDUWV
&DQFHOOLQJ7,0(5

&/5 EXWWRQ
3UHVVWKH&/5 EXWWRQWRFDQFHOWKHWLPHUVHWWLQJ
CAUTION
 When you select the timer operation, the remote
controller automatically transmits the timer signal
to the indoor unit at the specified time. Therefore,
keep the remote controller in a location where it
can transmit the signal to the indoor unit properly.
Otherwise, the time lag of up to 15 minutes will
occur.
 If you do not press the SET button within
2ZQHUҋV0DQXDO
OM_1123950201_EN-Book.indd 20 11/6/2562 BE 16:23
MODE button on the wireless remote controller.
the wired remote controller.
This disagreement indication cannot be deleted by
be cancelled.
30 seconds after setting the time, the setting will
10-EN
- 10 -