Why is my Toshiba RAV-HM801BTP-E Air Conditioner not cooling down?
Your Toshiba Air Conditioner might not be cooling down the room because the air intake or discharge of the outdoor unit is clogged. Also, check if any doors or windows are open, if the air filter is clogged with dust, if the air volume is set to “LOW”, or if the operation mode is set to “FAN”. Ensure that the setup temperature is appropriate.
What to do if my Toshiba Air Conditioner does not run?
If your Toshiba Air Conditioner isn't running, check if there has been a blackout, if the circuit breaker has blown, or if the protective device has been activated. If the protective device is activated, the operation indicator on the remote controller will be blinking.
How to clean a contaminated filter in a Toshiba Air Conditioner?
If the filter of your Toshiba Air Conditioner is contaminated, wash it with water.
What to do if there is dust or dirt clogging the drain pan in my Toshiba RAV-HM801BTP-E?
If the drain pan of your Toshiba Air Conditioner is clogged with dust or dirt, or if there's drain contamination, you should clean the drain pan. Also, verify the downward slope to ensure smooth drainage.
What to do if ornamental panel or louvers are contaminated in Toshiba Air Conditioner?
If the ornamental panel or louvers of your Toshiba Air Conditioner are contaminated, wash them or apply a repair coating.
What to do if air intake or discharge grilles are deformed in Toshiba RAV-HM801BTP-E Air Conditioner?
If the air intake or discharge grilles of your Toshiba Air Conditioner are deformed or damaged, fix or replace them.
What to do if Toshiba Air Conditioner fan has vibration or balance issue?
If the fan of your Toshiba Air Conditioner has terrible vibration or balance issues, replace it.
What to do if there is rust or peeling of insulator on exterior of Toshiba Air Conditioner?
If you notice rust or peeling of the insulator on the exterior of your Toshiba Air Conditioner, apply a repair coating.
General| Cooling Capacity | 8.0 kW |
|---|---|
| Heating Capacity | 9.0 kW |
| Refrigerant | R410A |
| Power Supply | 220-240 V, 50 Hz |
| Operating Temperature (Cooling) | 18°C to 46°C |
| Operating Temperature (Heating) | -15°C to 24°C |
Essential guidelines for safe operation, installation, and handling of the air conditioner.
Procedures and warnings related to the safe installation, electrical work, and refrigerant handling.
Critical advice for operating the unit safely, covering electrical hazards, moving parts, and environmental considerations.
Safety measures and advice for professional repair and relocation to prevent accidents.
Steps for preparing the unit for operation and understanding standby mode requirements.
Explains common sounds or conditions that are not indicative of a unit malfunction.
Guides users on checking common issues, viewing troubleshooting history, and identifying fault codes.
To Next Page
