To Next PageTo Next Page
Need help?Do you have a question about the Toshiba RAV-SM800AT-E and is the answer not in the manual?
General| Cooling Capacity | 8.0 kW |
|---|---|
| Heating Capacity | 9.0 kW |
| Energy Efficiency Ratio (EER) | 3.21 |
| Coefficient of Performance (COP) | 3.61 |
| Refrigerant | R410A |
| Power Source | 220-240V, 50Hz |
| Noise Level (Outdoor) | 52 dB(A) |
Details the parts included with the air conditioner unit.
Lists components that must be purchased separately for installation.
Instructions for safely suspending the indoor unit using hanging hardware.
Details how to attach filters and suction port canvases.
Steps for installing the wired remote controller.
Illustrates installation methods for concealed air duct systems.
Shows installation for ledge ceiling concealed air duct systems.
Presents charts showing static pressure vs. air volume for different models.
Explains proper methods for connecting air ducts and their insulation.
Offers general cautions and important points for air duct installation.
Specifies the required pipe material for drain systems.
Details drain pipe installation procedures and safety precautions.
Describes the application of thermal insulation to drain pipes.
Explains drain pipe setup for situations without a downward slope.
Instructions for securely connecting the drain hose.
Procedures to verify proper water drainage and check for leaks.
Covers requirements and methods for installing refrigerant pipes.
Information on allowable pipe lengths and heat-related considerations.
Explains the process of flaring copper pipes for connections.
Instructions for connecting refrigerant pipes to the outdoor unit.
Details the process of removing air from the refrigerant circuit.
Guidelines for charging the correct refrigerant quantity.
Methods for detecting potential refrigerant gas leaks.
Instructions for applying thermal insulation to refrigerant pipes.
Important advisory notes on power cord selection and wiring.
Critical safety warnings concerning electrical installation.
Step-by-step guide for performing the unit's wiring.
Details the process of connecting and securing electrical cables.
Specific instructions for wiring the remote controller unit.
Procedures to complete prior to initiating a test run.
Steps for performing the unit's operational test.
Specific test run instructions for wired controllers.
How to identify and confirm error codes displayed by the unit.
Procedure to access and review the unit's error history.
Information regarding initial remote controller operation acceptance time.
Explains the automatic addressing function for unit setup.
How to modify the indoor unit's control settings.
Step-by-step guide for changing control setup parameters.
Procedure for adjusting settings based on duct resistance.
Instructions for unit setup with optional filters.
How to adjust the filter cleaning notification timer.
Procedures for checking pipe connections and conducting tests.
Tips to improve heating performance in certain conditions.
Lists the essential tools required for installation and servicing.
Steps for cleaning the air conditioner's return grille.
Instructions for cleaning the unit's air filters.
