14
SETTING UP YOUR TV
From this menu, you can set the RF input configuration to
cable.
a
Press
MENU
, and select
SETUP
menu.
b
Use
b
to highlight
Ant/Cable In
and use
C
or
c
to
select
Antenna
or
Cable
.
NOTE:
When you attempt to change the
Ant/Cable
In
setting, a warning message will appear followed by
PIN entry (if PIN has been set) and a prompt for
Auto
Tuning
.
c
When
Ant/Cable In
is set to
Cable
, the following
setting options will be provided in the
Auto Tuning
screen.
Press
B
or
b
to select an item, and then press
C
or
c
to select your desired option.
With the exception of
DTV Scan Type
and
DTV Modulation
items, all of the following items will have 2 operating modes.
The first is
Auto
where the values for each item are preset by
the system. The second is an
Input
mode where you will be
able to enter a single value in place of the pre-set value. If no
channel is currently tuned and the
Input
state is chosen, a
system default value will be shown. However, if a channel is
currently tuned when the item is accessed, the value of the
current channel will be displayed.
DTV Scan Type:
This item determines whether a
Quick Scan
or a
Full Scan
will
be executed.
The
Quick Scan
is a simplified version of the
Full Scan
that is
designed to complete in less time.
DTV Start Frequency:
This sets the frequency from which the scan will begin.
DTV End Frequency:
This sets the frequency at which the scan will end.
* Valid entry range for frequency items is 113.000-858.00 for
C-Book/Other and 114.000-858.00 for Nordig-C. If
numbers outside of this range are entered, the values will
automatically be set to the min. or max. valid value as
appropriate.
DTV Modulation:
You can choose from five QAM modulation settings.
DTV Symbol Rate:
This is the baud rate (KS/s) of the scan.
* Valid entry range for Symbol Rate is 4000-7200. If a number
outside of this range is entered, the value will be
automatically set to the min. or max. valid value as
appropriate.
DTV Network ID:
This is the Network ID to be utilized for the scan. This item is
greyed out when DTV Scan Type is set to “Full Scan”.
* Valid entry range for Network ID is 1-65535. If a number
outside of this range is entered, the value will be
automatically set to the min. or max. valid value as
appropriate.
Ant/Cable In (if available)
Auto Tuning
DTV and ATVTuning Mode
DTV
Quick ScanScan Type
AutoStart Frequency
AutoEnd Frequency
AutoModulation
AutoSymbol Rate
AutoNetwork ID
Start Scan
00GB_RV-LV685D_UK.book Page 14 Tuesday, September 1, 2009 10:58 AM
To Next Page
Loading...
Need help?
General