Toshiba Satellite 1800 SERIES - Volume Control Board Removal

TOSHIBA
Tough Enough for Today’s World
FIELD REPLACEABLE UNIT DOCUMENTATION
1800 Series
FDD REMOVAL
1. Disconnect the FDD cable from PJ344 on the
system board.
2. Remove two M2.5x6 silver screws securing the
FDD assembly.
3. Lift out the FDD assembly.
4. Remove three M2.5x3 black screws securing the
FDD to the FDD case and separate the FDD from
the case.
5. Disconnect the FDD cable from the FDD.
FDD cable
PJ344
M2x3 silver screws
FDD cable
FDD assy
VOLUME CONTROL BOARD REMOVAL
1. Remove two M2.5x4 black flat head screws securing
the volume control board.
2. Disconnect the volume control cable from PJ61 and
the left speaker cable from PJ60 on the volume control
board.
SPEAKERS REMOVAL
1. Remove four M2.5x6 silver screws securing both
the left and right speakers.
2. Lift out both speakers.
Volume control board
M2.5x4
black
flat head
screws
Volume
control cable
Speaker cable
M2.5x6 Silver screws
Right
speaker
Left
speaker
Satellite
TM
M2.5x6 silver screws