10
Setting up your computer and getting started
RG 5.375 x 8.375 ver 2.3.4
1 If the computer is on, turn it off.
See “Turn Off or Shut down command” in your electronic user’s
guide.
2 Unplug and remove any cables connected to the computer.
3 Close the display panel and turn the computer upside down.
Underside of the computer
NOTE: Use a point size 0 Phillips screwdriver.
4 Locate the expansion memory slot cover and remove the screw that
secures the cover.
Removing the expansion memory slot cover screw
5 Using your finger or a narrow object, lift off the cover.
6 Put the screw and the cover in a safe place so that you can retrieve
them later.
CAUTION: Static electricity can damage the memory module. Before you handle the
module, touch a grounded metal surface to discharge any static electricity you may
have built up.
To avoid damaging the memory module, be careful not to touch its gold connector bar
(on the side you insert into the computer).
7 Remove the new memory module from its antistatic packaging.
8 Holding the memory module by its edges so that the gold connector
bar faces the slot, fit the module into the slot at a slight angle.
Expansion memory slot cover
To Next Page
Loading...
