17
Moving the computer
RG 5.375 x 8.375 ver 2.3.4
CAUTION: Make sure the disc is properly positioned on the spindle. If you position the
disc incorrectly, it can jam the disc tray.
6 Close the disc tray by pressing gently on the center of the tray until it
clicks, indicating that it is locked.
Removing a disc with the computer on
CAUTION: Never press the eject button while the computer is accessing the drive. Wait
for the Disk/disc activity light on the system indicator panel to turn off before opening
the disc tray.
1 Locate and press the eject button.
The disc tray partially opens.
2 Grasp the sides of the disc tray and pull it fully open.
3 Remove the disc from the disc tray and place it in its protective cover.
CAUTION: If the disc is spinning when you open the disc tray, wait for the disc to stop
before removing it.
4 Close the disc tray by pressing gently on the center of the tray until it
clicks indicating that it is locked.
Removing a disc with the computer off
1 Insert a slender object, such as a straightened paper clip, into the
manual eject button access hole.
CAUTION: Never use a pencil to press the manual eject button. Pencil lead can break
off inside the computer and damage it.
2 Pull the tray fully open, remove the disc and place it in its protective
cover.
3 Push the tray in to close the drive.
Moving the computer
Before moving your computer, even across the room, make sure all disk
activity has ended (the drive-in-use lights stop flashing) and all external
peripheral cables are disconnected.
CAUTION: Never pick up the computer by its display panel or by the back (where the
ports are located).
To Next Page
Loading...
