12
Inserting PC Cards
RG 5.375 x 8.375 ver 2.3.4
2 Push the latches to the outside to release the module. A spring will
force one end of the module up.
Removing the memory module
3 Gently pull the memory module out of the slot.
CAUTION: Avoid touching the connectors on the memory module or on the computer.
Grease or dust on the connectors may cause memory access problems.
4 Complete the procedure by following steps 10 through 12 in
“Installing additional memory (optional)” on page 9.
Checking total memory
When you add or remove memory, you can check that the computer has
recognized the change. To do this:
1 Click Start, Control Panel.
2 Click Performance and Maintenance.
3 Click System.
4 The General tab view automatically appears and shows the
recognized memory.
5 If the computer does not recognize the memory, turn off the computer,
remove the memory slot cover, and make sure the memory module is
seated properly, as described in steps 8 and 9 of “Installing additional
memory (optional)” on page 9.
Inserting PC Cards
Inserting a PC Card
1 If your PC Card does not support hot swapping, save your data and
turn off the computer before inserting the PC Card. For more
information, see “Hot swapping” on page 13.
2 Hold the PC Card with the arrow or main label side up and the
connector side toward the PC Card slot.
To Next Page
Loading...
