36
Installing additional memory (optional)
5.375 x 8.375 ver 3.1
13 If the computer does not recognize the memory, shut down the
computer, remove the keyboard and make sure the memory module is
seated properly, as described in step 7.
Removing a memory module
If you use the computer for a long time, the memory modules will become
hot. If this happens, let the modules cool to room temperature before you
replace them.
Do not try to remove a memory module with the computer turned on. You
can damage the computer and the device.
Do not remove the memory module while the computer is in Standby mode.
The computer could hang up the next time you turn it on and data in memory
will be lost. In either of the above cases, the Standby configuration will not
be saved.
The following message appears when you turn on the power:
Warning: Resume Failure
Press Any Key To Continue
If the computer hangs up when you turn it on, perform the following: Press
the power button and hold it down for five seconds until the power turns off,
then turn the power on again.
1 Follow steps 1 through 5 in “Installing additional memory (optional)”
on page 30.
2 Pull the clips away from the memory module.
The memory module pops partially out of the slot.
Pulling the clips away from the memory module
To Next Page
Loading...
