User’s Manual 2-30
The Grand Tour
Replacing the batteries
When the batteries in the Remote Controller reach the end of their life, the
Remote Controller may not operate correctly or work only within a short
distance from your computer. In this instance, you should purchase new
batteries and replace the discharged ones.
1. Open the battery cover on the back of the Remote Controller.
2. Replace the batteries.
Be sure to place the batteries with their polarities (+ and -) in the correct
position.
Figure 2-15 Removing the batteries
3. Close the battery cover until it clicks.
Type of battery that can be used for the Slim Size Remote Controller
When the batteries shipped with the Remote Controller are discharged,
replace them with commercially available CR2016 Lithium batteries. Other
types or battery should not be used.
Installing the battery
1. Open the battery cover on the back side of the remote controller.
Figure 2-16 Opening the battery cover
2. Be sure to place the battery with correct polarities. Press the battery
down to the stopper then push it forward to fit into the battery case.
To Next Page
Loading...
