User’s Manual 4-16
Operating Basics
3. Lay the CD/DVD/BD, label side up, in the disc tray.
Figure 4-6 Inserting a CD/DVD/BD
4. Press gently at the center of the CD/DVD/BD until you feel it click into
place. The CD/DVD/BD should lie below the top of the spindle, flush
with the spindle base.
1. Laser lens
1
When the disc tray is fully opened, the edge of the computer will extend
slightly over the CD/DVD/BD tray. Therefore, you will need to turn the
CD/DVD/BD at an angle when you place it in the disc tray. After seating the
CD/DVD/BD, however, make sure it lies flat.
■ Do not touch the laser lens or any portion of its surrounding casing as
this could cause misalignment.
■ Prevent foreign objects from entering the drive. Check the surface of
the disc tray, especially the area behind the front edge of the disc tray,
to make sure there are no such objects before closing the drive.
To Next Page
Loading...
