4.2 HDD 4 Replacement Procedures
3. Remove the HDD pack by pulling on the tab attached to the pack, following the
direction of the arrows.
NOTE: Do not disassemble the HDD pack when it is working normally. Disassemble
or replace the HDD pack only if it fails.
4. Place the HDD pack on a flat surface (such as a desk), and remove the two M3x4
black flat head screws with M3x4 black head screws.
5. Place the HDD pack on a flat surface (such as a desk), and remove the chassis.
M3x4 Black
flat head screw
HDD
HDD chassis
M3x4 Black
flat head screw
Figure 4-6 Removing the HDD chassis
CAUTION: Do not apply pressure to the top or bottom of the drive.
Satellite L350/ Satellite Pro L350/ EQUIUM L350/ SATEGO L350 Maintenance Manual 4-17
To Next Page
Loading...
