Toshiba Satellite M45 - Installing the Removing North Bridge Thermal Module

4.13 North Bridge thermal module 4 Replacement Procedures
Installing the Removing North Bridge thermal module
Install the Removing North Bridge thermal module according to the following procedures
and Figure 4-35.
1. Place the north bridge thermal module in the correct position and push the clip in
correct position on the system board.
2. Secure two north bridge thermal module screws.
3. Connect the North Bridge thermal module cable to the CN513 on the system board.
Satellite M40/M45, TECRA A4, dynabook Vx/4 Maintenance Manual 4-51