4 Replacement Procedures 4.18 Switch Cover and Switch Board
4.18 Switch Cover and Switch Board
Removing the Switch Cover and Switch Board
Remove the Switch Cover and Switch Board according to the following procedures and
Figure 4-42, 4-43.
1. Remove the following 6 latches on the switch cover, in that order:
-Three latches on each of the left and right sides
Figure 4-42 Removing the switch cover
2. Disconnect the switch board flat cables from CN3002 on the switch board.
3. Remove two M2.5x4 black flat-head screws.
4. Remove the switch board.
4-60 Satellite M40/M45, TECRA A4, dynabook Vx/4 Maintenance Manual
To Next Page
Loading...
