User’s Manual 2-20
The Grand Tour
Installing the battery
1. Open the battery cover on the back side of the remote controller.
2. Slide the battery out of battery case.
Figure 2-14 Installing/Replacing the battery
3. Insert the new battery in place. Be sure to place the batteries with
correct polarities. Push it forward to fit into the battery case.
4. Close the battery cover securely.
AC adaptor
The AC adaptor can automatically adjust to any voltage ranging from 100 to
240 volts and to a frequency of either 50 or 60 hertz, enabling you to use
this computer in almost any country/region. The adaptor converts AC
power to DC power and reduces the voltage supplied to this computer.
To recharge the battery, simply connect the AC adaptor to a power source
and to the computer. Please refer to Chapter 6, Power and Power-Up
Modes for further information.
Figure 2-15 The AC adaptor (2-pin plug)
Made in China
MCE IR Remote Control
Model: G83C000BF116
1x 3V CR2032 Lithium battery
To Next Page
Loading...
