Figure 4-6 Releasing the battery pack
1. Battery lock 3. Battery pack
2. Battery release latch
Installing the battery pack
To install a battery pack, do the following:
Do not touch the battery release latch while holding the computer or the
battery pack might fall out due to the unintentional release of the battery
release latch and cause injuries.
1. Insert the battery pack as far as it will go into the computer.
2. Ensure that the battery pack is securely in place and the battery lock is
in its locked (
) position.
3. Turn your computer over.
Additional memory module
This section is only applicable for models equipped with the memory
module cover.
You can install additional memory into the computer in order to increase
the amount of system memory that is available. This section describes how
to install and remove optional memory modules.
You should place a mat beneath the computer in order to prevent the
computer's lid from scratches or damages when you are installing/
replacing the memory module. In this instance, you should avoid mats
that are made of materials that hold or generate static electricity.
When installing or removing a memory module, you must ensure that
you do not touch any other internal areas of the computer.
Use only memory modules approved by TOSHIBA.
User's Manual 4-22
To Next Page
Loading...
