Toshiba SD-2550A - Remote Control Operation; Battery Installation & Use

1-7
14
Introduction
Identification of Controls (continued)
The instructions in this manual describe the functions on the remote control. See the page in
for details.
Remote control
* MENU button
Use the MENU button to display the menu included on
many DVD video discs. To operate a menu, follow the instructions in “Locating a title using the top menu.”
30
TOP MENU
MENU
ENTER
RETURN
CLEAR
21
456 78
3 90
+10
T
RANDOM
REPEAT
A-B RPT
ANGLE SUBTITLE AUDIO
SETUP SLOWZOOMDISPLAY
MEMORY
SEARCH
SKIPREV
STOP PLAY
PAUSE/STEP
FWD
OPEN/CLOSE
FL SELECT
E.A.M. E.P.M.
FL DIM
OPEN/CLOSE button
26
PAUSE/STEP button
27 28
SETUP button
48
ANGLE button
41
42
SUBTITLE button TOP MENU button
30
CLEAR button
31
REV button
28
FWD button
28
27
E.A.M. button
40
E.P.M. button
39
STOP button RANDOM button
37
MEMORY button
36
MENU button*
RETURN button
48
ENTER button
48
FL DIM button PLAY button
26
SKIP buttons
31
A-B RPT button REPEAT button
Power button
26
SLOW button
29
ZOOM button
38
AUDIO button
43
Direction buttons
( / / / )
48
Number buttons
31
DISPLAY button
44
T button
31
35 35
13
FL SELECT button
13
15
Operating with the remote control Point the remote control at the remote sensor and press the buttons.
Distance: About 7 m from the front of the remote
sensor
Angle: About 30° in each direction of the front of
the remote sensor
* Do not expose the remote sensor of the DVD video
player to a strong light source such as direct sunlight or other illumination. If you do so, you may not be able to operate the DVD video player via the remote control.
Notes on the remote control • Direct the remote control at the remote sensor of the DVD
video player.
• Do not drop or give the remote control a shock. • Do not leave the remote control near an extremely hot or
humid place.
• Do not spill water or put anything wet on the remote
control.
• Do not open the remote control.
Open the cover.
Insert batteries (R6 size).
Make sure to match the + and – on the batteries to the marks inside the battery compartment. Close the cover.
Notes on batteries Improper use of batteries may cause battery leakage and corrosion. To operate the remote control correctly, follow the instructions below. • Do not insert batteries into the remote control in the wrong
direction.
• Do not charge, heat, open, or short-circuit the batteries.
Do not throw batteries into a fire.
• Do not leave dead or exhausted batteries in the remote
control.
• Do not use different types of batteries together, or mix old
and new batteries.
• If you do not use the remote control for a long period of
time, remove the batteries to avoid possible damage from battery corrosion.
• If the remote control does not function correctly or if the
operating range becomes reduced, replace all batteries with new ones.
• If battery leakage occurs, wipe the battery liquid from the
battery compartment, then insert new batteries.
1 2 3
Loading batteries
1
2
About the illustrations of the battery compartment There are two types of battery compartment in the
supplied remote controls. (This does not mean a difference in performance between the two.) Refer to either illustration depending on the actual remote control.
Within about 7 m
30°
30°