NOTE : When reassembly perform the
procedure in the reverse order.
1 Drum Assembly 3 Screw A-1 T
2 Plate Top 2 Hook A-2 T
2 3 Holder Assembly CST Chassis Hole A-2 T
2 4 Opener Door Chassis Hole A-2 T
5 Bracket Assembly 3 Hook A-2 T
L/D Motor
2,3,4 6 Gear Assembly Rack F/L 1 Hook, Chassis Hole A-2 T
2,3,4,6 7 Arm Assembly F/L Chassis Hole A-2 T
8 Lever Assembly S/W 1 Hook A-2 T
9 Arm Assembly Cleaner Chassis Embossing A-3 T
10 Head F/E Chassis Embossing A-3 T
11 Base Assembly A/C Head 1 Screw A-3 T
2,3 12 Brake Assembly T 1 Hook A-4 T
2,3 13 Brake Assembly RS 1 Hook A-4 T
2,3 14 Arm Assembly Tension 2 Hook A-4 T
2,3,12,13, 15 Reel S/Reel T A-4 T
14
16 Base Assembly P4 Chassis Embossing A-5 T
17 Opener Lid Chassis Embossing A-5 T
17 18 Arm Assembly Pinch Shaft A-5 T
17 19 Lever T/Up / Arm T/Up 1 Hook A-5 T
17,18 20
Belt Capstan/Motor Capstan
3 Screw A-6 B
21 Lever F/R Locking Tab A-6 B
20, 21 22 Clutch Assembly D35 Washer A-6 B
23 Brake Assembly Capstan Locking Tab A-6 B
24 Gear Drive/Gear Cam Washer/Hook A-7 B
25 Gear Sector 1 Hook A-7 B
20,21,23, 26 Plate Slider Shaft Guide A-7 B
24,25
20,21,23, 27 Lever Tension 1 Hook A-7 B
24,25,26
2,3,14,20, 28 Lever Spring Locking Tab A7 B
21,25,23,
24,26
25 29
Gear Assembly P2/Gear Assembly P3
Boss A-8 B
2,3,14,25, 30
Base Assembly P2/Base Assembly P3
Chassis Slot A-8 B
29
2,3,14,25, 31 Base Loading 1 Screw A-9 T
29
2,3,14 32 Base Tension Chassis Embossing A-9 B
2,3,20,21, 33 Arm Assembly Idler Locking Tab A-9 T
22
Starting
No.
Procedure
Part Fixing Type
Fig-
ure
Vi-
ew
1) When reassembling, confirm Mechanism and Mode
Switch Alignment Position (Refer to Page 4-13)
2) When disassembling, the Parts for Starting No. Should
be removed first.
T:Top, B:Bottom
To Next Page
Loading...
