Toshiba SD-V395 - Page 44

DISASSEMBLY INSTRUCTIONS
B3-4
NOTE
1.
2.
3.
In case of the Idler Arm installation, install as the circled
section of Fig. 3-10-B.
In case of the Idler Arm Spring installation, install as the
circled section of Fig. 3-10-C.
In case of the Chassis Spring installation, install as the
circled section of Fig. 3-10-D.
Idler Arm
Main Chassis Ass’y
Fig. 3-10-B
Fig. 3-10-C
Idler Arm Spring
Main Chassis Ass’y
Fig. 3-10-D
Chassis Spring
Main Chassis Ass’y
3-11: FEED MOTOR (Refer to Fig. 3-11-A)
1.
2.
3.
Remove the 2 screws 1.
Remove the Feed Motor.
Remove the Motor Gear.
• Screw Torque: 1 ± 0.5kgf•cm
Fig. 3-11-A
NOTE
1.
2.
In case of the Motor Gear installation, check if the value
of the Fig. 3-11-B is correct.
When installing the Feed Motor, check if the cable is
positioned as Fig. 3-11-C.
Motor Gear
Feed Motor
6.1 ± 0.1mm
Safety surface for pressing
of the insert.
Fig. 3-11-B
Main Chassis Ass’y
Feed Motor
Pass the cable
between 2 pins.
Fig. 3-11-C
11
Main Chassis Ass’y
Motor Gear
Feed Motor