49
ALARM SETUP
The Sensor and Output Window allows you to enable, disable and configure Sensors and Control Outputs.
Configure Sensor Response
1. Click the Setup Button on the Main Display Screen.
2. Click the Alarm Setup Button to open the Sensor and Output Display.
3. Click to select NO or NC for the desired sensor.
4. Enter the Delay Time to define the number of seconds after the sensor is tripped until the relay is activated.
5. Enter the relay(s) to associate with the sensor. Two or more relays can be associated with a single sensor – separate with
commas.
6. Click Apply.
Configure Hybrid (IP) Sensors*
*Requires the HVR Software Upgrade
Normally Open (NO)
Normall
Closed
NC
Open On-Screen Keyboard
Create & Name Sensor Presets
Delay Triggering Relay Output
Assign Relay(s)
comma delineated
To Next Page
Loading...
