Toshiba T3100e - Field Replaceable Units (FRUs) Overview

File No.
4.1 GENERAL
This PART describes how to remove the following Field
Replaceable Units (FRUs):
1. Keyboard
2. Speaker
3. Extension board
4. PDP (plasma display panel) mask
S. PDP unit
6. PDP cover
7. LED board
8. Top cover
9. Power supply unit
10. Power supply cover
11. Disk support
12. Plasma sensor
13. Lithium battery
14. FDD
IS. HDD
16. Cooling fans
17. Cooling fan holder
18. Handle
19. System board
The following points must be kept in mind:
960-010
1. The system should never be disassembled unless there is
a problem (abnormal operation, etc.)
2. Only approved tools may be used.
3. After deciding the purpose of replacing the unit, and
the procedures required, do not carry out any other
procedures which are not absolutely necessary.
4. B~ sure to turn the power switch off before beginning.
S. Be sure to disconnect the AC cord and all external
cables from the system unit.
6. Follow the only fixed, standard procedures.
7. After replacing a unit, confirm that the system is
operating normally.
Tools needed for unit replacement:
1. Phillips head screwdriver.
2. Tweezers.
4-1