Toshiba T3100e - Power Supply Unit Removal;Replacement

File No.
960-010
4 .9 POWER SUPPLY UNIT
WARNING: Pay attention to handling the power supply unit to
which high voltage is supplied. Note that it will take a
few minutes to discharge the electricity after power-off.
1. Remove the keyboard, PDP mask, PDP unit, LED board and
PDP cover with top cover according to sections 4.2 and
4.4 through 4.8.
2. Disconnect a connector (A) from the power supply board
(PJ4) .
3. Remove the power supply unit (B) by removing 5 screws
(e), lift up it, then disconnect the connecter (D) from
the system board (PJ7).
(C)
~.>r---(A)
(0)
Figure 4-14 Power supply unit
4. Reverse procedure to install.
4-15