Toshiba T3100e - Disk Support, Plasma Sensor, Lithium Battery Removal

File No. 960-010
4.11 DISK SUPPORT, PLASMA SENSOR AND LITHIUM BATTERY
1. Remove the keyboard, PDP mask, PDP unit, LED board, PDP
cover with top cover and power supply unit according to
sections 4.2 and 4.4, through 4.9.
2. Remove the disk support (A) by removing 2 screws (B).
3. Lift the disk support, then disconnect 4 connectors (C)
from the system board (D).
4. Remove the plasma sensor (E) by removing flat head
screw (F).
5. Disconnect the battery connector (G) from the system
board, then remove the lithium battery (H) fixed on the
system board with a snap-on fastener.
Figure 4-16 Disk support, plasma sensor and lithium battery
6. Reverse procedure to install.
4-17