Toshiba T3100e - Plasma Display Connector Check

File No.
960-010
PROCEDURE 3
PDP Connector Check
WARNING: Dangerous high voltage is supplied to the plasma
display panel. Pay enough attention on handling.
1. Turn off the power, then unplug the AC power cord.
2. Remove the PDP without disconnecting the cables (Refer
to section 4.5.) and check that the cables are securely
connected to the plasma display board (Refer to figure
2-3.)
3. If the cable is securely connected, go to PROCEDURE 4.
4. If the cable is not securely connected, secure it.
Figure 2-3 PDP connector check
2-40