Toshiba T5200 - Page 22

³ 20 ³ FDC Error ³
³ 40 ³ Seek Error ³
³ 60 ³ FDD Not Drive ³
³ 80 ³ Time Out Error ³
³ EE ³ Write Buffer Error ³
ÀÄÄÄÄÁÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ
<fig id=MMS\5200\52002_24.TIF>Page 2-24</fig>
PROCEDURE 5
FDD Connector Check
1. Turn off the power, then unplug the AC power cord.
2. Remove the top cover. (Refer to section 4.3.)
3. Check that the FDD connection (PJ14) is secure.
4. If the FDD cable is securely connected to the system board, go to
PROCEDURE 6.
5. If the FDD cable is not securely connected to the system board,
secure the connection.
<fig id=MMS\5200\52002_25.TIF>Page 2-25</fig>
PROCEDURE 6
New FDD Connection
1. Turn off the power.
2. Remove the FDD. (Refer to section 4.7.)
3. Connect a new FDD to the FDD connector without installing the new
FDD. Then connect all of the FRUs removed during FDD removal to
their corresponding connectors without installing the FRUs.
4. Turn on the power.
5. If normal operation is restored, the original FDD is probably
defective. Reassemble the system.
6. If normal operation is not restored, the system board is probably
defective. Refer to section 2.4.
~~
DOC:MAINTENANCE MANUAL
MODEL:T5200
MODEL:T5200C
CHAP:2 PROBLEM ISOLATION PROCEDURES
SECT:2.6, HARD DISK DRIVE PROBLEM ISOLATION PROCEDURES
DOC_ID:2.6 T5200
LANG:ALL
TEXT:
<fig id=MMS\5200\52002_26.TIF>Page 2-26</fig>