³ CAUTION: Do not type an MS-DOS acceptable command such as ³
³ del and format. Such operation may erase your important ³
³ program or data. ³
ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ
If the character you press appears on the screen, press Enter
key. Go to PROCEDURE 2.
4. If the character does not appear on the screen, go to PROCEDURE 3.
Toshiba Personal Computer MS-DOS Version X.XX /(RXXXXX)
(C) Copyright Toshiba Corporation 1983,1986
(C) Copyright Microsoft Corporation 1981,1986
Current date is XXX X_XX_19XX
Enter new date ( mm-dd-yy): _
Current time is X:XX:XX,XX
Enter new time: _
COMMMAND Version X.XX
A> abcdefghijilmnopqrst ...........
<fig id=MMS\5200\52002_36.TIF>Page 2-36</fig>
PROCEDURE 2
Keyboard Test Execution
1. Insert the diagnostics disk into the FDD. Then type a:testce52
and press Enter key and run the keyboard test as indicated on
the diagnostic test menu.
2. If an error is detected during the test, go to PROCEDURE 3.
3. If no error is detected during the test, the keyboard is normal.
<fig id=MMS\5200\52002_37.TIF>Page 2-37</fig>
PROCEDURE 3
Connector Check
1. Turn off the power, then disconnect the AC power cord.
2. Lift up the top cover. (Refer to section 4.3.)
3. Lift up the keyboard and check that the keyboard cable (PJ1) is
securely connected to the system board. If it is securely connected,
go to PROCEDURE 4.
4. If it is not securely connected, secure it.
<fig id=MMS\5200\52002_38.TIF>Page 2-38</fig>
PROCEDURE 4
New Keyboard Connection
1. Turn off the power, then unplug the AC power cord.
To Next Page
Loading...
