Media in drive#1 mode (0:2DD,1:2D,2:2D-2HD/2DD,3:2HD) ?
3. Select the media type of the floppy disk to be tested, then press
the Enter. The following message will appear.
Test start track (Enter:0/dd:00-79) ?
<fig id=MMS\5200\52003_18.TIF>Page 3-18</fig>
4. You can select the start track number of the floppy disk test.
When pressing the Enter only, the start track number will be
zero.
If you desire, select the start track number. Then the subtest menu
of the floppy disk test will appear.
5. During the floppy disk test, the message shown below will appear.
The ADDRESS number indicates that the first XX shows a
cylinder number, the third X shows a head number, and the
last XX shows a sector number.
The STATUS number indicates that the first X shows a
drive number and the last XX shows an error status code.
FLOPPY DISK XXXXXXX
SUB-TEST : XX
PASS COUNT : XXXXX ERROR COUNT : XXXXX
WRITE DATA : XX READ DATA : XX
ADDRESS : XXXXXX STATUS : XXX
CONTENTS
Subtest 01 Sequential read
This subtest performs the CRC (cyclic redundancy check)
with a continuous read operation of all tracks on a
floppy disk.
2D (Double-sided, double-density): Track 0 to 39. 2DD
(Double-sided, double-density, double-track) and 2HD
(Double-sided, high-density, double-track): Track 0 to
79.
The start track can be specified at the previous stage.
Subtest 02 Sequential read/write
This subtest writes data to all tracks (as defined above)
continuously and then reads the data out and compares it
with the original data.
(The data pattern is B5ADADH repeated.)
Subtest 03 Random address/data
This subtest writes random data to random address on all
tracks (as defined in subtest 01) and then reads the data
out and compares it with the original data.
<fig id=MMS\5200\52003_19.TIF>Page 3-19</fig>
Subtest 04 Write specified address
To Next Page
Loading...
