Toshiba T5200 - Page 57

3 - Bad track FORMAT
4 - Bad track CHECK
9 - Exit to DIAGNOSTICS MENU
Press [NUMBER) key ?
2. All track FORMAT Selection
(1) When all track FORMAT (1) is selected, the following message
will appear.
Drive number select (1:#1, 2:#2) ?
(2) Select a drive number. Type the drive number and press
Enter. The following message will appear.
Interleave number (3/1-3) ?
(3) Select an interleave number. (Usually select 1.) Type the
number and press Enter. The following display will
appear.
[HDD TYPE]: CYLINDER = XXX
[HDD TYPE]: READ = X
[HDD TYPE]: SECTOR = XX
[WARNING: Current DISK data will be completely destroyed]
Press [Bad track number (CCCH)] key ?
[[cylinder, head = XXX X]]
(4) After pressing the Enter, the [[cylinder, head = XXX
X]] message will appear; then all cylinders of the hard
disk are formatted and checked.
(5) After formatting the hard disk, the Format complete
message will then appear.
(6) Press the Enter to return to the HARD DISK FORMAT menu.
<fig id=MMS\5200\52003_34.TIF>Page 3-34</fig>
3. Good track FORMAT or Bad track FORMAT Selection
(1) When Good track FORMAT or Bad track FORMAT is selected, the
following message will appear.
Drive number select (1:#1, 2:#2) ?
(2) Select a drive number. Type the drive number and press
Enter. The following message will appear.
Interleave number (3/1-3) ?
(3) Select an interleave number. (Usually select 1.) Type the
number and press Enter. The following message will
appear.
[HDD TYPE]: CYLINDER = XXX