plasma font set
Plasma gray scale mode: Select either 2 gray levels (T3100
compatible mode), or 16 gray levels that supports a display of 16
colors.
- T3100 compatible mode: Specifies 2 gray levels. This is the
default setting.
- 16 gray scales mode: Specifies 16 gray scale levels.
Plasma font style: Select either single-dot font or double-dot font
for both the Normal and the Intense character attributes.
- Normal: Single. Intense: Double. (This is the default value.)
- Normal: Single. Intense: Single. (If you select "16 gray scales
mode" above, you must select this option.)
- Normal: Double. Intense: Double.
- Normal: double. Intense: Single.
<fig id=MMS\5200\52003_51.TIF>Page 3-51</fig>
Plasma font set: Select one of the following character font sets:
- Standard: Specifies the standard North American character set.
(This is the default setting.)
- North European: Specifies the North European font.
- Canadian French: Specifies the Canadian french font.
- Reserved.
Plasma display adapter = Not used
The internal display controller is not used. There are no
additional display options when this is selected.
4. Printer Port Type
This option sets the PRT/FDD connector on the rear panel of
the T5200 to either an output-only or a bi-directional port. This
option is valid only when the PRT/FDD connector is used for
the printer, that is , the A B PRT switch is set to
PRT. This setting depends on the printer or other parallel
devices you attach to the PRT/FDD connector.
when you have printer connected, you should usually select
output-only port.
-Output-only port (This is the default setting.)
-Bi-directional port
5. Serial Port
This option allows you to change the I/O addresses and interrupt
To Next Page
Loading...
