Toshiba T5200 - Page 78

speaker (M)
<fig id=MMS\5200\52004_4.TIF>Figure 4-5</fig> Removing the speaker
9. To install the keyboard and the speaker, follow the above
procedures in reverse.
~~
DOC:MAINTENANCE MANUAL
MODEL:T5200
MODEL:T5200C
CHAP:4 REPLACEMENT PROCEDURES
SECT:4.3, REMOVING/REPLACING THE TOP COVER
DOC_ID:4.3 T5200
LANG:ALL
TEXT:
<fig id=MMS\5200\52004_5.TIF>Page 4-5</fig>
4.3 REMOVING/REPLACING THE TOP COVER
1. Remove the AC power cord from the unit.
2. Turn the unit upside down and remove the six screws (A) from the
bottom cover.
<fig id=MMS\5200\52004_5.TIF>Figure 4-6</fig> Removing the six screws
3. Turn the unit back over then pull out the converter mask panel (B)
to remove the two screws (C) from the converter unit (D).
<fig id=MMS\5200\52004_5.TIF>Figure 4-7</fig> Removing the converter
mask panel and the screw
<fig id=MMS\5200\52004_6.TIF>Page 4-6</fig>
4. Open the mask plate (E) to press the both release levers (F) inside
and down.
<fig id=MMS\5200\52004_6.TIF>Figure 4-8</fig> unlocking the release
levers
5. Unplug the display from display connector (G).
<fig id=MMS\5200\52004_6.TIF>Figure 4-9</fig> Removing the display
<fig id=MMS\5200\52004_7.TIF>Page 4-7</fig>
6. Remove the keyboard as directed in section 4.2 and remove the screw
(H) from top cover (I)
<fig id=MMS\5200\52004_7.TIF>Figure 4-10</fig> Removing the three screws
7. Remove the two screws (J) from the rear panel (K) to remove the
rear panel.
<fig id=MMS\5200\52004_7.TIF>Figure 4-11</fig> Removing the rear panel
<fig id=MMS\5200\52004_8.TIF>Page 4-8</fig>