Toshiba TCB-IFTH1GUL - Page 11

24V Thermostat Interface
Installation Manual
11-EN
 Fan speed (Cooling, Heating) settings
SW01-3, SW01-4: The Indoor Unit’s fan speed during Cooling or Heating mode operation can be set according to the following table.
If G1/G2/G3 input is used, the fan speed will be determined by G1/G2/G3 signal from the Thermostat.
 Wind direction (Cooling) settings
SW01-5, SW01-6: The Indoor Unit’s wind direction during Cooling mode operation can be set according to the following table.
 Wind direction (Heating) settings
SW01-7, SW01-8: The Indoor Unit’s wind direction during Heating mode operation can be set according to the following table.
 Temperature control settings (Variable/Fixed)
SW02-1: The 24V Thermostat Interface controls the Indoor Unit by the dry-contact signals from the Thermostat and the room
temperature sensed by the Indoor Unit. There are two control modes configurable by the 24V Thermostat Interface.
Auto (default) mode provides more comfortable operation by varying the compressor speed. On the other hand,
Fixed capacity mode provides On/Off controls instead of varying the compressor speed.
SW01-3
SW01-4
Operation
OFF
OFF
Auto (Default)
OFF
ON
Low fan speed
ON
OFF
Medium fan speed
ON
ON
High fan speed
SW01-5
SW01-6
Operation
OFF
OFF
Determined by Remote Controller setting.
(Default)
OFF
ON
F3 (Refer to Owner’s Manual of RC)
ON
OFF
F2 (Refer to Owner’s Manual of RC)
ON
ON
F1 (Refer to Owner’s Manual of RC)
SW01-7
SW01-8
Operation
OFF
OFF
Determined by Remote Controller setting.
(Default)
OFF
ON
F5 (Refer to Owner’s Manual of RC)
ON
OFF
F4 (Refer to Owner’s Manual of RC)
ON
ON
F2 (Refer to Owner’s Manual of RC)
SW02-1
Operation
OFF
Auto (Default), Variable capacity mode
ON
Fixed capacity mode
F1
F2
F3
Wind direction Image (Refer to Owner’s Manual of Remote Controller)
F4
F5
Wind direction Image (Refer to Owner’s Manual of Remote Controller)
F2