To Next PageTo Next PageWhat to do if Toshiba TDP-T8 Projector remote or control panel fails?
If your Toshiba Projector's remote controller or control panel fails, check the Battery. Then, check the Remote Controller itself, the IR receiver, the FPC (Keypad Cable), and the keypad. Finally, check the Main Board.
How to troubleshoot no power on my Toshiba Projector?
If your Toshiba Projector has no power and no LED is lit, ensure that the power cord and AC power outlet are properly connected. Also, make sure that all connectors are securely connected and aren’t broken. You may also need to check the Keypad Board, Keypad Cable, LVPS, and Main Board.
What to do if my Toshiba Projector has no image but the LED is lit?
If your Toshiba Projector has no image or display, but some LEDs are lit, ensure that the signal cable and source work well. Also, ensure that all connectors are securely connected and aren’t broken. You may need to check the Lamp Door, Limit Switch, Thermal Switch, Thermal Sensor, Fans, Color Wheel, Lamp, Lamp Driver, Main Board, and DMD Board. Consult the LED Lighting Message for additional guidance.
Why is my Toshiba TDP-T8 image flickering?
If your Toshiba Projector image is flickering, try doing a “Reset” of the OSD Menu. Ensure that the signal cable and source work well. You may also need to check the Lamp Module, Photo Sensor, Color Wheel, DMD Board, and Main Board.
How to fix color abnormalities on Toshiba Projector?
To fix color abnormalities on your Toshiba Projector, first try doing a “Reset” of the OSD Menu. You can also try to adjust the Color Wheel Index and perform PC on Video Calibration. If the issue persists, check the Main Board, DMD Board, and Color Wheel.
What to do if my Toshiba TDP-T8 keeps shutting down automatically?
If your Toshiba Projector is automatically shutting down, check the LED Status by referring to the LED Lighting Message. Also, check the Color Wheel and photo sensor. You may also need to refer to the “No Power” troubleshooting steps.
Why does my Toshiba TDP-T8 Projector have poor uniformity or shadows?
If your Toshiba Projector has poor uniformity or shadows, ensure the projection screen is free of dirt and that the projection lens is clean. Also, ensure the Brightness is within specification. If the Brightness is less than specified, replace the Lamp. You may also need to check the Engine Module.
Why is my Toshiba TDP-T8 making mechanical noises?
If your Toshiba Projector is making mechanical noises, check the Color Wheel and Fan Module.
How to remove dead pixels or dust from Toshiba TDP-T8?
To address dead pixels or dust issues on your Toshiba Projector, ensure the projection screen is free of dirt and the projection lens is clean. You may also need to clean the DMD Chip and Engine Module. Additionally, check the DMD Chip and Engine Module.
How to fix line bars or defects on Toshiba TDP-T8 Projector?
To fix line bars or defects on your Toshiba Projector, check the DMD Board and DMD Chip. Also, check the Main Board.
General| Contrast Ratio | 2000:1 |
|---|---|
| Display Technology | DLP |
| Lamp Type | UHP |
| Lamp Life | 2000 hours |
| Inputs | VGA, S-Video, Composite Video |
| Projection Size | 27 to 300 inches |
| Native Resolution | 1024 x 768 |
