59
Getting Started
Adding memory (optional)
5.375 x 8.375 ver 2.3
13 Once the module’s connector is fully inserted into the
socket, press downward on the top edge of the module to
seat the module into the latches at the sides of the socket.
These latches should “snap” into place securely with the
corresponding cutouts in the side of the module. If the
latches and cutouts do not line up correctly, repeat step 12
above, then repeat this step.
(Sample Illustration) Inserting the memory module into the
slot
Do not force the memory module into position. The
memory module should be completely inserted into the
socket and level when secured in place.
(Sample Illustration) Pressing down on the memory module
Memory slots
Front of computer
latch
latch
To Next Page
Loading...
