76
Getting Started
Turning off the computer
Configuring Hibernation mode options
You can place the computer into Hibernation mode by either
pressing the power button or closing the display panel. You can also
specify an amount of time after which the computer automatically
goes into Hibernation mode.
To use any of these methods, you first need to enable them in
Toshiba’s Power Saver utility.
1 Click Start, Control Panel, and then Performance and
Maintenance.
2 Click the TOSHIBA Power Saver icon.
3 Click the Setup Action tab.
4 Select Hibernation for the options you want.
These options are set separately for how they operate while the
computer is running on battery power or while connected to the AC
power.
❖ When I press the power button
Set this option to Hibernate if you want the computer to
go into Hibernation mode when you press the power
button.
❖ When I close the lid
Set this option to Hibernate if you want the computer to
go into Hibernation mode when you close the display
panel.
5 Click Apply.
6 Click OK.
Once the computer is configured, you can place it into Hibernation
mode by either pressing the power button or closing the display
panel, depending on the Hibernation options set.
Starting again from Hibernation mode
To start up the computer from Hibernation mode, press the power
button until the on/off light glows green. The computer returns to
the screen(s) you were using.
If you put the computer in Hibernation mode by closing the display
panel, you can start it again by opening the display panel.
To Next Page
Loading...
Need help?
General
