User’s Manual 4-15
Operating Basics
Loading discs
To load CD/DVDs, follow the steps as detailed below:
1. When the computer’s power is on, press the eject button to open
the disc tray slightly.
2. Grasp the disc tray gently and pull until it is fully opened.
Figure 4-5 Pressing the eject button and pulling the disc tray open
3. Lay the CD/DVD, label side up, in the disc tray.
Figure 4-6 Inserting a CD/DVD
1. Disc tray 2. Eject button
1. Laser lens
1
2
1
When the disc tray is fully opened, the edge of the computer will extend
slightly over the CD/DVD tray. Therefore, you will need to turn the CD/DVD
at an angle when you place it in the disc tray. After seating the CD/DVD,
however, make sure it lies flat.
To Next Page
Loading...
