User’s Manual 3-25
Hardware, Utilities and Options
5. Loosen the screw securing the memory module cover in place - please
note that the screw is attached to the cover in order to prevent it from
being lost.
6. Slide your fingernail or a thin object under the cover and lift it off.
Figure 3-8 Removing the memory module cover
7. Align the notch of the memory module with that of the memory slot and
gently insert the module into the slot at about a 30 degree angle before
holding it down until the latches on either side snap into place.
Figure 3-9 Seating the memory module
Use a point size 0 Phillips screwdriver.
1. Memory module cover
2. Screw
1. Notch
3. Slot A
2. Slot B
1
2
1
2
3
To Next Page
Loading...
