3-6 User’s Manual
Replacing the memory module
4. Remove two screws securing the keyboard as shown in the illustration
below.
Removing the keyboard brace and two screws
5. Lift the back of the keyboard toward you and lay it face down on the
palmrest as shown in the illustration below.
Lift the keyboard
Only remove the keyboard brace after completing steps 1-3. Otherwise,
you may damage the keyboard brace.
Keyboard
brace
Screws
Use a size 0 Phillips screwdriver.
■ When you move the keyboard forward, do not touch the keys. Doing so
could cause misalignment. Hold the keyboard by the sides and lay it
gently on the palmrest.
■ The keyboard is connected to the computer by a ribbon cable. Be
careful not to apply tension to this cable when you lift the keyboard. Do
not disconnect this cable.
To Next Page
Loading...
