User’s Manual 2-1
Memory Module Replacement Guide
Chapter 2
Before you start the replacement
Be sure to read the User’s Guide provided with your computer and then
perform the following steps.
1. Turn the computer’s power off. Be sure the computer is not in sleep,
suspend, or hibernate mode. Make sure the Power indicator is off.
2. Remove AC adapter and all cables and devices connected to the
computer.
3. Turn the computer upside down and remove the battery pack. Refer to
the instructions for removing the battery pack in the User’s Guide for
your computer.
When you have completed the steps above, proceed to Chapter 3:
Replacing the memory module.
■ Do not try to install or remove a memory module unless you have
completed steps 1 through 3 above. You can damage the computer
and the memory module and you may lose data.
■ Only install the memory module in the computer for which it was
intended. If the memory is incorrectly installed, or installed in the wrong
computer, the computer will issue a series of short beeps. If this occurs,
shut down the power and remove the memory module.
■ Be careful not to let screws or other foreign objects fall into the
computer. It may cause damage or injury.
Use a size 0 Phillips screwdriver to remove and secure screws. Use of an
incorrect screwdriver can damage the screw heads.
To Next Page
Loading...
