User’s Manual 3-1
Memory Module Replacement Guide
Chapter 3
Replacing the memory module
This chapter explains how to replace the memory module(s).
1. Removing the memory module cover
1. Remove or loosen the screws securing the memory module cover.
2. Lift off the cover.
For the following models:
■ The replacement procedure depends on the model of the computer.
Check your model and refer to the instructions for that model.
■ Most computers have two memory slots. Be sure to remove the
affected memory module(s) before installing the replacement(s). The
illustrations below may only show one memory module being replaced.
If both modules are affected, the procedure must be repeated for each
affected module.
Use a size 0 Phillips screwdriver.
■ TECRA S1
■ TECRA 9100
■ TECRA M1
■ TECRA M2
■ Satellite 2400
■ Satellite 2405
■ Satellite 1110/1115
■ Satellite Pro M10
■ Satellite Pro M15
■ Satellite M30/M35
■ Portégé R100
■ Portégé M200/M205
■ Do not touch the connectors on the memory module or on the
computer. Contamination on the connectors may cause memory
failures.
■ Do not leave foreign objects or dropped screws in the computer.
To Next Page
Loading...
