Figure 4-5 Removing the AccuPoint cap
1. AccuPoint cap
Product appearance depends on the model you purchased.
2. Position a new cap on the peg and press it into place.
The peg is square, so be careful to align the cap’s square hole with
the peg.
You can buy replacement AccuPoint caps from your TOSHIBA
authorized dealer.
Using the Fingerprint Sensor
Some models have a fingerprint utility installed for the purpose of enrolling
and recognizing fingerprints. By enrolling the ID and password onto the
fingerprint authentication feature, it is no longer necessary to input the
password from the keyboard. Fingerprint feature enables you to:
Logon to Windows and access a security enabled homepage through
Internet Explorer.
Files and folders can be encrypted/decrypted and third party access to
them prevented.
Unlock the password-protected screen-saver.
Authentication of the User Password (and, if applicable, the HDD/SSD
Password) when booting up the computer (Pre-Boot authentication).
Single Sign-On feature
Fingerprint cannot be used in models that do not have a fingerprint module
installed.
How to Swipe your Finger
Using the following steps when swiping fingers for fingerprint registration or
authentication can help to minimize authentication failures:
Align the first joint of the finger to the center of the sensor. Lightly touch the
sensor and swipe finger levelly towards you until the sensor surface
User's Manual
4-13
To Next Page
Loading...
Need help?
General
