UPSMON PRO User Guide 96449-001 5
Setting up Shutdown Configuration
Once the power failure occurs, it helps you to automatically shut down Windows and
the
UPS:
1. Button: Run Time
2. (a) Shutdown Type
2. 1 Hibernate: power-saving state and puts your open documents and programs on your hard disk
2. 2 Shutdown: completely close the procedures and save your programs to the hard disk
2. 3 None: no action for the Operating System
----------------------------------------------------------------------------------------------------------------------
NOTE: In Windows 2003 and XP ==> You also have to enable the hibernate in Power Options
Properties to support OS Hibernate
----------------------------------------------------------------------------------------------------------------------
3. (b) "Power Failure Windows Shutdown Delay": after this period of time, the OS starts to
shutdown - (1)
4. (c) "Battery limited capacity shutdown": once the battery is declining to this level, the OS starts to
shutdown - (1)
5. (d) "Low battery shutdown": if the status of the battery is declining to low level, the OS
immediately shuts down - (1)
---------------------------------------------------------------------------------------------------------------------
If any one of the (1) item-conditions is fulfilled, UPSMON PRO will execute shutdown / hibernate.
---------------------------------------------------------------------------------------------------------------------
6. (e) "Execute Command File" : when the (1) seconds runs out, it will activate the chosen command
To Next Page
Loading...
