Screw (5)
Screw (7)
Power supply
cord holder (4)
Screw (5)
Main PC board (8)
Rear Panel (6)
Cam switch (1)
Align marks
6. Remove the power supply cord holder (4) from the
chassis.
7. Remove the two screws (5) to detach the rear
panel(6).
8. Remove the screw (7) to detach the main PC board
(8).
Fig. 1-5-3
1-5-3. Mechanical Deck Mounting
1. When mounting the mechanical deck, align the
marks of the cam switch (1) on the main PC board.
Fig. 1-5-4
2. After mounting the mechanical deck, bring it to the
state that the cassette holder is just out.
To Next Page
Loading...
