16
Introduction for special function
About switch between Fahrenheit and Centigrade
Under status of unit off, press MODE and - buttons simultaneously to switch ℃ and ℉.
Press “TEMP” and “CLOCK” simultaneously in COOL mode to start energy-saving fun-
ction. Nixie tube on the remote controller displays “SE”. Repeat the operation to quit
the function.
Combination of "TEMP" and "CLOCK" buttons:
About Energy - saving Function
About Quiet function
When quiet function is selected:
About Sleep function
1. Under cooling mode: indoor fan operates at notch 4 speed. 10 minutes later or when
2.
Under the Fan、Dry and Auto mode, the Sleep function cannot be set up, Select and
enter into any kind of Sleep mode, the Quiet function will be attached and stared,
different Quiet status could be optional and turned off.
Under heating mode: indoor fan operates at notch 3 speed or quiet mode according
to the comparison between indoor ambient temperature and set temperature.
cooling, heating or fan mode.
3. Under dry, fan mode: indoor fan operates at quiet mode.
indoor ambient temperature≤28℃, indoor fan will operate at notch 2 speed or quiet
mode according to the comparison between indoor ambient temperature and set tem-
perature.
4. Under auto mode: the indoor fan operates at the auto quiet mode according to actual
Combination of "TEMP" and "CLOCK" buttons:
About 8
℃
Heating Function
Press “TEMP” and “CLOCK” simultaneously in HEAT mode to start 8
℃
Heating Function
Nixie tube on the remote controller displays “ ” and a selected temperature of “8℃”.
(46℉ if Fahrenheit is adopted). Repeat the operation to quit the function.
To Next Page
Loading...
Need help?
General
