3
from yourself before you switch on
the trimmer.
25. Do not operate the grass trimmer
on wet grass, or under damp
conditions.
26. T
ake special care in slippery
conditions on slops and uneven
ground.
27.
Watch for hidden obstacles such
as tree stumps and roots to avoid
stumbling
28. Chec
k the cutting head at regular
intervals. If the behavior changes
(excessive noise, vibration etc.)
immediately:
Switch off!
Holding the trimmer firmly press the
head against the ground and bring
to a complete stop.
Disconnect the mains supply.
Check the condition of the cutting
head; look for damage, missing
parts and crac
ks.
29. Have the damaged cutting head
replaced immediately even if it only
has superficial cracks. Never at
tempt
to repair a damaged cutting head
30. Only use original cutting heads
and replacement spools. Never use
metal cutting lines.
31
.
Warning! Danger of injury by the
line cutting device. After replacing
a spool, be sure to bring the unit
into normal working position before
turning it on again.
32.
Clean the plastic parts with damp
cloth only.
33. Never leave you grass trimmer
outdoors in the rain. Store your tool
in a dry place, keep out of reach
of children.
34.
Warning!
1) The nylon line continues to rotate
after the motor is switched off.
2) Do not put your hands or feet
near or under the rotating parts
when the machine rotating
3) Never pick up or carry the
trimmer while the motor is running.
4) S
witch off the trimmer and
disconnect the power supply, if:
You leave the machine
Before checking, cleaning and
working on the appliance.
After striking a foreign object.
Inspect the appliance for damage.
The grass trimmer starts to vibrate
abnormally.
35. Always ensure that ventilation
openings are kept clear of debris.
36. Take care against injury from the
blade fitted for trimming the cutting
line.
Warning! There is a sharp blade
fitted to the guard for cutting the
line to length. Keep your fingers
clear.
37. After extending new cutting line
always return the machine to its
normal position before switching
on.
Important note
Remove the mains plug from socket
before carrying out any adjustment or
ser
vicing.
38. Always ensure that ventilation
openings are kept clear of debris.
39. Take care against injury from the
blade fitted for trimming the cutting
line to length. After extending
new cutting line always return the
machine to its normal position
before switching on.
40. All electric power tools should
be properly insulated and any
extension cables should be orange
so it will stand out when laid around
the garden
41
. When using a hand controlled
electric tool, feed the cable over
your shoulder, this should prevent
you cutting through it.
To Next Page
Loading...
