7
ASSEMBLY INSTRUCTION
Assembling Grass Trimmer (see Fig1,
Fig2 and Fig3)
Fig 1 Fig 2
Fig 3
Note: The machine may be fully
assembled, however this instruction
gives you full assembly details.
Inser
t the upper parts into lower part
firmly until a “click” is heard. Note: the
screw holes should be on the same side.
Guard Fitting
1. Position motor head/axle as shown in
Fig4, with screw fixing hole at the top
centre (remove pre-fitted screw).
2. Position guard with inner side, ie.
moulding facing you as shown in Fig5.
3. Lower the guard o
ver the motor head/
axle (see Fig6) and align slots as shown
in Fig7 (note position of the tab).
4. Align marks on head of the unit and
the guard, turn the guard in a cloc
kwise
direction, see Fig7.
Fig 4
Fig5
Fig 6
Fig 7
To Next Page
Loading...
