5. OPERATING PROCEDURES
(a) Turn the Engine switch to the position
"ON".
(b) Open the fuel valve to position "ON".
STARTING THE GENERATOR
Check the fuel level before each operations as outlined by the article
"CHECK MIXED FUEL"
CAUTION
ON
OFF
ON
OFF
OFF
Pull briskly
(c)
Pull the starter handle slowly until
passing the compression point
(resistance will be felt), then return
the handle to its original position
and pull briskly.
If the engine fails to start after several
attempts, repeat above procedures
with choke lever returned to "OPEN"
position.
Do not fully pull out the rope.
After starting, allow the starter handle
to return to its original position while
still holding the handle.
(d)Warm up the engine without a load for
a few minutes.
To Next Page
Loading...
