Need help?Do you have a question about the Total TWP775016 and is the answer not in the manual?
Store pumps indoors in a dry, vibration-free, and dust-free environment.
Avoid subjecting products to needless jolts or collisions during transport.
Installation and operation must be performed by skilled and qualified personnel.
Ensure electrical system compliance and follow safety regulations.
Procedure to verify the motor shaft turns freely for proper operation.
Manufacturer not liable for damages from tampering or incorrect use.
Ensure the installation site is free from sediment and pump is raised.
Details on operating temperature, immersion, and frost-free housing.
Guidance on hydraulic connections, pipe diameter, and float switch.
Electrical installation must be performed by an authorized and competent electrician.
Verify mains voltage matches data plate and ensure a good ground connection.
Information on cable replacement, dedicated power lines, and switchgear.
Steps for starting the pump, including switch operation and water flow check.
Ensure suction filter is present and avoid excessive starting frequency.
Prevent damage from freezing when the pump is inactive below 0°C.
Rinse pump with water after use with deposit-forming substances.
Pump requires minimal maintenance due to oil bath lubricated seal and bearings.
Jobs require qualified personnel; disconnect power and handle parts carefully.
Manufacturer disclaims responsibility for unauthorized modifications.
Use only original spare parts and manufacturer-approved accessories.
Diagnosing and resolving problems with the motor not starting or making noise.
Troubleshooting issues related to the pump not delivering water.
Resolving faults where the pump fails to stop operating.
Diagnosing and fixing low flow rate issues.
Addressing issues where the overload protection device stops the pump.
Store pumps indoors in a dry, vibration-free, and dust-free environment.
Avoid subjecting products to needless jolts or collisions during transport.
Installation and operation must be performed by skilled and qualified personnel.
Ensure electrical system compliance and follow safety regulations.
Procedure to verify the motor shaft turns freely for proper operation.
Manufacturer not liable for damages from tampering or incorrect use.
Ensure the installation site is free from sediment and pump is raised.
Details on operating temperature, immersion, and frost-free housing.
Guidance on hydraulic connections, pipe diameter, and float switch.
Electrical installation must be performed by an authorized and competent electrician.
Verify mains voltage matches data plate and ensure a good ground connection.
Information on cable replacement, dedicated power lines, and switchgear.
Steps for starting the pump, including switch operation and water flow check.
Ensure suction filter is present and avoid excessive starting frequency.
Prevent damage from freezing when the pump is inactive below 0°C.
Rinse pump with water after use with deposit-forming substances.
Pump requires minimal maintenance due to oil bath lubricated seal and bearings.
Jobs require qualified personnel; disconnect power and handle parts carefully.
Manufacturer disclaims responsibility for unauthorized modifications.
Use only original spare parts and manufacturer-approved accessories.
Diagnosing and resolving problems with the motor not starting or making noise.
Troubleshooting issues related to the pump not delivering water.
Resolving faults where the pump fails to stop operating.
Diagnosing and fixing low flow rate issues.
Addressing issues where the overload protection device stops the pump.
General| Model | TWP775016 |
|---|---|
| Category | Water Pump |
| Type | Submersible |
| Max Head | 8m |
| Material | Plastic |
| Cord Length | 10m |
| Weight | 5.5kg |
| Voltage | 220-240V |
| Frequency | 50Hz |
| Power | 750W |
To Next Page
