TotalPond 52411 - PREPARATION; Package Contents; OPERATION INSTRUCTIONS; Container Setup and Initial Assembly

Visit WWW.TOTALPOND.COM for information and tips.
EN
EN
6
Please call Customer Care before returning item to store: 1-888-412-6001
7
PACKAGE CONTENTS
PREPARATION
Before beginning assembly or operation of product,
make sure all parts are present. Compare parts with
package contents list and diagram. If any part is missing
or damaged, do not attempt to assemble, install or
operate the product. Contact Customer Care for
replacement parts.
• Estimated assembly time: 30 minutes
• Tools required for assembly: container, plastic liner or
sealant, drill, 1-1/4 in. drill bit, silicone caulk, and latex
gloves
Part Description Qty
A
Filter box with pump, LED
light, and rubber stopper
1
B Filter box extensions 4
C Extension tube 1
D Waterspray nozzle 1
E Waterbell nozzle 1
F Trumpet nozzle 1
G Lower fountain head nozzle 1
H Cord holder 1
I Container stand 3
Liner
C
D
E F
G
G
C
C
1
2
3
Cord
4
To run the cord over the side of the container, proceed to
step 4 . To drill a hole in the side wall of the container to
run the cord through, proceed to step 5 . To run the cord
through the bottom of the container, skip to step 7.
Step 4. Place the assembled
fountain kit in the container, and
drape the cord over the side of
the container. Continue to step
10.
OPERATION INSTRUCTIONS
Step 1. Pick a container you
want to use.
If the container is not
already watertight, us
a liner or sealant. If you
use a sealant, follow label
directions before adding
water.
Step 2. Connect the
extension tube to the
lter box.
Step 3. Choose a fountain
nozzle for the desired water
effect, and assemble to the
top of the extension tube as
shown.